Description
Mini PIX Flight Controller – RADIOLINK
- Mini PIX Flight Controller V1.2
- Small flight controller with the same Functions as PIXHAWK
- Better Altitude Hold
- Vibration Damping by Software
- Equipped with a processor, a barometer, an accelerometer, a compass, etc.
- Compatible Models: Fixed wing / 3 to 6 Multicopter / Helicopter / Cars / Boats
The Mini PIX Flight Controller is based on the mature research and development of PIXHAWK. The Radiolink mini PIX is equipped with a STM32F405VGT6 processor, a LPS22HB barometer, a MPU6500 accelerometer and a QMC5883L compass with the same technology as in the HMC5983. It has a shell completely closed to protect the interaction effects of air current wake on air pressure during flight.
The main board has air pressure vent to ensure accuracy of the barometer testing. Its shell design and vibration damping with the software make the Mini Pix better in Altitude Hold Effect.
Also check our wide range of flight controllers , Drone transmitter and receiver and other good quality drone parts .
Specifications of Mini PIX Flight Controller :
- SAFETY/BUZZER: B+ B- 3.3V LED SAFETY
- POWER: GND GND VOTAGE(up to 3.3V) CURRENT(up to 3.3V) VCC(5V) VCC(5V)
- RC IN/RSSI: VCC(5V) RC RSSI GND
- GPS/I2C: VCC(5V) TX(OUT 3.3V) RX(IN 3.3V) SCL(3.3V pullups) SDA(3.3 pullups) GN
- TELEM1: VCC(5V) TX(OUT 3.3V) RX(IN 3.3V) CTS(3.3V) RTS(3.3V) GND
- TELEM2: VCC(5V) TX(OUT 3.3V) RX(IN 3.3V) CTS(3.3V) RTS(3.3V) GND
- USB
Hardware
- Processor: STM32F405VGT6
Sensor
- Sensor: Gyro MPU6500
- Compass: QMC5883L
- Barometer: LPS22HB
- Connector: JST GH connector
- Mavlink UART: 2(with CTSRTS)
- GPS UART: 1
- RC In signal input: PPM/SBUS
- RSSI signal strength input: PWM/3.3V
- I2C: 1
- PWM input: 6 OneShot/PWM output
- Buzzer: 1
- Switch: 1
- Power: 1
Compatible Models
- Fixed wing/3 to 6 Multicopter/Helicopter/Cars/Boats
Operating Parameters
- PM operate voltage: 5.1V
- USB voltage: 5V+-0.3V
- Servo voltage: Do not support input
- Temperature: -40~80°C
What’s Included
- 1x I2C Transfer Board Connect Cable
- 1x FC Status Indicate LED
- 1x Mini Pix
- 1x Power Module(Support 2-12S)
- 1x Double-sided Adhesive Tape
- 1x FC Status Indicate LED Connect Cable
- 1x USB Cable
- 1x Power Module Connect Cable
- 1x Double-sided Adhesive Tape
- 1x Buzzer&Safety Switch
- 1x Packing Box
Dimensions of Mini PIX Flight Controller :
- 39x39x12mm
- Weight: 12g (without wires)
Reviews
There are no reviews yet.